How To Fix Garbage Disposal Back Up

How to fix garbage disposal with water that comes back up.

How to fix garbage disposal back up. If it does not flow down repeat plunging on the garbage. Remove the rubber catch or cover if needed and slide a hex wrench or wooden spoon into the disposal. Point a flashlight down into your garbage disposal and pull out any visible blockages with tongs. Then wait about thirty minutes to allow these ingredients to break down whatever might be responsible for the blockage. But if the sink has some water already that s fine though make sure its just three to four inches.

To fix a clogged garbage disposal turn off the disposal using the circuit breaker and shine a flashlight down into the disposal to see the clog. Usually the fix involves disassembling the drain trap and discharge pipe and removing any food waste clogging the pipes. Remove the plunger and unplug the garbage disposal drain. Avoid using your hands to protect yourself from possible injury. Let at least three to four inches of water into that sink.

Check for clogs or obstructions and clean out any you find. Plug the drain you just plunged and run water into the garbage disposal drain. When you re sure the drain is working properly you can do a bigger flush by putting a stopper over the disposal opening filling up the sink basin with hot water and quickly pulling out the stopper. Pour a mix of baking soda and vinegar down your drain. Remove the bolts holding the discharge pipe to the disposal.

Run water down through the disposal for several minutes to flush any loose debris through the drain system. Disconnect the drain trap and remove the trap and the discharge drain pipe. Once the key start moving freely plug your garbage disposal back again press the reset button again and see if the disposal is working or not. If your garbage disposal starts working then run some water through it and check for any leaks.