How To Use Drywall Anchors With Wings

The anchor won t function properly unless this is done even though it might feel strong when it s screwed in.

How to use drywall anchors with wings. As with the expansion anchor drive it in until it sits flush with the drywall. Once the anchor is in place a wand included with the anchor is pushed through the hole to expand the wings on the backside. You need to fold back the wings and then insert the unit into the wall and it will then spread back out to create a sturdy hold. Then take your power drill and drive the threaded anchor into the drywall just like you would with a normal screw. A screw is then inserted which draws the wings snugly against the.

Use a drill bit that s the same size as the dry wall anchor. Slide the bracket or object you wish to secure. These wings can be pressed down so that they are parallel to the screw. Butterfly anchors are a classic type and they re arguably the strongest type of drywall anchors. Plasterboard wall anchors i discovered these p.

To use dry wall anchors start by drilling a hole into the wall you re installing the anchors in at a 90 degree angle. The wings are pulled firmly against the wall after the screw is installed. The metal sleeves utilize two spring loaded wings that open inside the wall. Pull the plastic taut until it is flush with the wall. Picture a long screw with two perpendicular wings at the end just like this one link to amazon.

They can hold between 25 and 35 pounds each when used in drywall. Remove the wing or butterfly piece from the screw or bolt that came with it. Drill a hole in the wall the same width as the butterfly drywall anchor. Start by drilling a hole about the size of the tip of the threaded anchor. Plastic anchors should be installed carefully to prevent them from being damaged.

Insert the metal portion into the hole. Use a 1 2 inch pilot bit to drill a hole into the wall.